Elegant Anniversary Cake Recipes

Steps:

• Heat oven to 350°F. Grease bottoms only of 2 (8-inch) square cake pans with shortening or cooking spray.
• Make and bake cake mix as directed on box for 8-inch cakes. Cool 10 minutes. Run knife around side of pans to loosen cakes; remove from pans to cooling rack. Cool completely, about 1 hour.
• On serving plate, place 1 cake layer. Spread with about 1/2 cup white frosting. Top with second layer. Frost sides and top. Using black decorating icing, pipe desired designs on sides and top of cake. Place candles on cake. Store loosely covered at room temperature.

Steps:

• In a bowl, combine the confectioners' sugar, 1/3 cup water, meringue powder and cream of tartar; beat on low speed just until combined. Beat on high for 7-10 minutes or until stiff peaks form. (Keep icing covered at all times with a damp cloth to keep from drying out. If necessary to restore texture later, beat again on high speed. Prepare only half of the icing recipe if using store-bought candy roses or edible flowers to decorate.), ROSES: Divide icing in half; set half aside. If using store-bought roses, refer to photo for position and attach roses to top of cake using a dab of icing. If making icing roses, cut a hole in the corner of pastry or plastic bag; insert round tip # 12 and fill with remaining icing. Holding the bag straight up, pipe a dome-shaped mound or icing on the flower nail., With petal tip #103 and icing, hold pastry bag with narrow end farther away from the rose tip and turning the nail, pipe a row of three standing petals. Pipe a second row of petals, holding the narrow tip end at a greater angle. Repeat for a third row., Gently slide scissor ends underneath rose and remove it from nail to waxed paper; let dry completely. Repeat with remaining icing to make 20-22 roses. (Flowers can be made several weeks in advance and stored in an airtight container.), NUMERALS AND CAKE TOPPER: Set aside 1/2 cup of reserved icing. With round tip #4 and remaining reserved icing, pipe at least ten 3/4-in.-square "25"s, making sure to connect the two and five at the base of each., For cake topper, place pattern of your choice under waxed paper; tape both to work surface. Completely outline edges; let dry for 10 minutes. To reserved 1/2 cup icing, stir in remaining 2-3 teaspoons water to thin. Fill in outline of cake topper with thinned icing, using the same tip. Let dry completely, thin place in an airtight container to store before use., CAKE: Line two greased 12-in. round baking pans with parchment or waxed paper; grease and flour paper and set aside. In a bowl, cream shortening and sugar. Add eggs, one at a time, beating well after each. Combine the flour, baking powder and salt; add to the creamed mixture alternately with the milk. Stir in additional cake ingredients based on the desired cake flavor. Pour into prepared pans. Bake at 350° for 50-55 minutes or until a toothpick inserted in the center comes out clean. Cool for 10 minutes before removing from pans to wire racks to cool completely., FROSTING: In a large bowl, cream the butter, shortening and confectioners' sugar until well combined. Beat in milk, vanilla and salt until mixture becomes light and fluffy., ASSEMBLING: Split each cooled cake into two horizontal layers. Place bottom layer on serving plate; spread with a thin layer of frosting. Top with 3/4 cup filling of your choice. Spread a thin later of frosting over the bottom of next layer; place cake, frosted side down, over filling. Repeat layers twice. Top with remaining cake layer., Set aside 3 cups frosting. Tint remaining frosting with color of your choice; set aside 1/2 cup. Spread remaining tinted frosting over top and sides of cake. Place reserved tinted frosting in a pastry or plastic bag with round tip #4. Pipe lettering and outlines over cake topper. Let dry., FINISHING: Place reserved white frosting in a pastry bag with star tip #21. Pipe eight vertical columns around sides of cake. With the same tip, pipe a shell border around top and bottom of cake., Just before serving, use small dabs of frosting to attach numerals between columns and roses at top of columns. Stand cake topper up in center of cake; continue to hold while piping two large dollops of frosting on either side of cake topper. Using leaf tip #69, pipe leaves around cluster of roses. (Dried decorations will collapse upon refrigeration. Remove to save.)

Steps:

• MAKING THE CAKES: Make the basic Easy vanilla cake recipe (see 'Goes well with'), following the instructions below for each tier, then cool and drench with the syrup. The cakes can be frozen ahead, without icing. However, if you bake them three days before the wedding, the cake will be fine until the big day.
• For the bottom tier, triple the quantities for the basic cake mix, then spoon into a ready-lined deep round 30cm cake tin. Bake for 2 hrs 15 mins on the middle shelf until risen and cooked through as before. While this cooks, make up a quadruple batch of the syrup - this will be enough for all three cakes. Cool and drench the cake with syrup as before.
• For the middle and top tiers, double the quantities for the basic cake mix, then spoon it into ready-lined 15cm and 23cm cake tins, filling each to about two-thirds full. Bake them together on the middle shelf, taking the small cake out after 1 hr 15 mins, and leaving the larger cake to cook for 1 hr 30 mins in total. If you know that your oven has hot spots, quickly move the cakes around after 50 mins. Cool and drench with syrup as before.
• LAYER AND COVER THE CAKES: Make the buttercream as in the basic recipe. You will need 5 x basic quantity - this is a lot, so split your weighed-out quantities in two before you start mixing. You may have some left over, but better too much than too little. Weigh out the buttercream - you will need approximately 400g for the 15cm cake, 600g for the 23cm cake and 1.3kg for the 30cm cake. Spread a little buttercream over the 15cm cake board. Level the top of the cake if you need to, then upturn the 15cm cake onto it. Split into three using a bread knife. I like to mark the front of the cake on each layer before lifting it off, using toothpicks, so I can reassemble it in exactly the right way. Take the top third off first (what was the bottom of the cake) and set aside. Carefully cut the middle layer and set that aside, too. A flat baking sheet or cake lifter can be very helpful here to slide the cake layers off and then back onto each other.
• Spread a layer of buttercream over the cake on the board. Return the middle layer, lining up the toothpick markings, then spread another layer of buttercream on top. Add a little jam if you like, dotting it over, then spreading evenly. Top with the final piece of cake, then dust off any crumbs on or around the cake. Now brush the whole cake with a thin layer of apricot jam. This should stop you getting too many crumbs in the buttercream. Sit the whole cake on a large sheet of baking parchment.
• Spread the rest of the buttercream over, starting with the top, then smooth and paddle it around the sides and down to the board. Repeat the whole process with the remaining cakes, using the corresponding boards and the different quantities of buttercream. The cakes are now ready to be iced. You can leave them overnight if needed, loosely covered with cling film.
• COVERING THE CAKE WITH ICING: You will need about 500g icing for the 15cm cake, 1kg for the 23cm cake and 1.7kg for the 30cm cake. Dust the work surface with icing sugar, knead the icing until pliable, then use your rolling pin to roll it into a circle large enough to cover the sides and top of the cake, with a little left over. Use string to check the size. Use your rolling pin to help you lift the icing over the cake.
• Smooth the icing around the cake with your hands, easing it over the edges and down to the board. Then trim off the excess with a sharp knife, flush with the bottom of the cake board. Smooth any marks with the flats of your hands, buffing the icing to a slight shine.
• Once you've iced all the cakes, cover the thick base board. Lightly brush with cooled boiled water, then lay the icing over. Trim to the edge of the board with a knife (I tend to do this like I would a pie crust, holding the board in my left hand, and knife in my right), then leave the board and the cakes to dry overnight.
• STACKING THE CAKES: Dowels, which are basically plastic sticks, provide stability and strength to tiered cakes, and polystyrene blocks allow you to add a 'floating' layer of flowers. By measuring and cutting the dowels to the same length as the polystyrene, you'll provide an even platform for the next cake to sit on, even if the cake below is a bit wonky.
• Sit the 15cm dummy centrally on top of the biggest cake. Insert four of the dowels into the cake, around the outside of the dummy, in a square shape. Push them right down until they meet the cake board. Mark with a pen where the top of the dummy comes to.
• Carefully pull out the dowels; then, using scissors, score around each dowel where you marked it. Snap the plastic cleanly. Re-insert the dowels in their original holes, rounded end down. Repeat the process with the 23cm cake and the 12cm dummy.
• Position the biggest cake in the middle of the covered board. Run a thin line of glue around the base board and fix the ribbon around it. Fix the ribbon around each cake, using a spot of the glue on the ribbon to secure it to itself. If you're moving the cake to a venue, put the cakes into their boxes now. Make a little kit to take with you - glue, scissors, etc - just in case you have to re-do anything.
• ON THE DAY - STACKING AND DECORATING THE CAKE WITH FLOWERS: I used hydrangeas - they're beautiful, in season and you can achieve a dramatic effect with relatively few blooms. On the day, save putting the flowers on the cake until as late as you reasonably can. Cut the stems of the hydrangeas to about 2-3cm. Split your least-favourite bloom into smaller pieces - this will help you fill any awkward gaps later. Make sure you save one beautiful bloom for the top.
• Insert a length of floristry wire into each stem (or wind it around the stem), leaving a spike of wire about 3cm long. Push this into the polystyrene dummy. Repeat until the two dummies are surrounded with a halo of flowers. The bottom cake should be in its permanent position now - out of direct light and away from any radiators. Lift the 23cm cake onto the bottom polystrene dummy, taking care not to squash any petals, then repeat with the top cake. Fill any gaps with the broken-up flower head you reserved earlier. Sit the final bloom on top of the cake, and you're done!
• CUTTING THE CAKE: Cut the cake across, in a grid, rather than into wedges. You should be able to get 50 servings from the large cake, 30 from the middle and 12 from the top, when cut into 2.5 x 5cm pieces.