Somebunnylovesyoueastercake Recipes

Steps:

• For the frosting: Combine the sugar, butter and salt in the bowl of a stand mixer fitted with a paddle attachment (or in a large bowl if using a hand-held electric mixer). Mix on low speed until mostly incorporated. Add the vanilla, increase the speed to medium high and mix until smooth. Adjust the consistency with milk until the frosting is easy to spread.
• For the bunny: Spread a thin layer of frosting (about 2/3 cup) on the flat side of one cake layer and top with the flat side of the second cake layer. Measure 5 inches across the top of the cake and cut down through the layers, creating 2 layered pieces that are slightly different sizes.
• Place the larger piece of cake cut-side down on a large platter or cake board. If using a rectangular cake board, place the larger piece so that the long edges are parallel with the long edges of the board. This is the body of the bunny. Cut the smaller piece of cake in half crosswise, so you have 2 layered wedges. Place one wedge in front of the body, with one flat side on the board and the other flat side against the body. The curved side will be on top. Take a serrated knife and round off the sharp edges on top of the head. Cut the tip off (the nose) at a 45-degree angle. Reserve all scraps in a bowl.
• Separate the layers of the remaining wedge of cake. These will be the back legs. Round the sharp edges of the cake wedges with your knife and add to the scrap bowl. Place one piece on each side of the bunny, with one flat side down and the other flat side facing forward (the round side towards the back of the bunny), about 1 inch from the end of the bunny's body.
• Mix the cake scraps in the bowl with a fork until mashed and then pack into a ball with your hands. Place the ball behind the bunny's body and adhere with a dab of frosting. This is the bunny's tail.
• Frost the entire bunny, tail and all, using 2 to 3 cups of the frosting, keeping some definition with the bunny parts and frosting more generously around any sharp edges to give a rounded look to the bunny parts. Sprinkle the bunny with the coconut to fully cover. Gently pat to adhere.
• Insert the biscotti between the head and body, pressing into the cake to secure them. These are the ears. Place the base of the ears close together at the center of the head and angle them out. Frost the front of each biscotti with some frosting. Then, using the pink decorating icing, frost a smaller strip in the center of each biscotti, going down to where the ears meet the head but not going all the way to the top.
• To make the face, press a black jelly bean into each side of the head for the eyes. Cut one of the marshmallows into 3 circles, discard the middle piece and press the 2 end circles, cut-sides in, into the front of the face for the bunny cheeks. Push the white jelly bean halves into the face below the cheeks, round-sides out, for the teeth. Place the pink jelly bean above for the nose.
• Unroll the licorice wheel and cut 2 pieces, each about 1 1/2 inches long. For each piece, peel the strips apart halfway down and then cut each separated strip in half lengthwise so you end up with a piece looking a bit like a broom. Repeat with the second piece of licorice. Tuck each piece, with a dab of frosting, behind a marshmallow cheek, with the cut ends facing out for the whiskers.
• Cut the second marshmallow in half lengthwise. Make 3 slits in each half, going about halfway through (these are the toes), and place in front of the legs for the bunny's feet. Adhere the bottom of the feet with frosting if necessary.

Steps:

• Prepare cake mix according to directions on box for 2 round 9" layers.
• Tint 1/4 cup of the coconut pink (I'm guessing at the amount) for the center of ears and feet.
• Tint 2 tablespoons of the frosting brown for decorating face and feet ( or you can buy one of those prepared decorating icing tubes).
• When cake is cool, cut layers as shown in diagram (see other photo).
• Take 4 of the 8 outer ring pieces and frost the tops. Place 1 of the remaining 4 on top of each and frost top and sides. These will make the feet of the bunny.
• Place round-cut center piece next to the top edge of the square, keeping them both flat, to form body and head.
• Assemble the 4 side pieces in twos, flat sides together (you can use a little frosting to hold them together) to form the ears and arrange at the top of the head.
• Frost entire cake and attach the completed feet, 2 on each side of the body.
• Sprinkle coconut over entire cake and decorate with jelly beans/gumdrops for eyes, nose, etc. as desired, using pink-tinted coconut for center of ears and feet.
• Here's where you can really have fun and get creative! You can tie the ribbon in a bow and place on the cake as a bowtie, make buttons out of the candy, add a hat, etc.
• ** Tip for using frosting to decorate without a pastry bag: Spoon the frosting into one corner of a small plastic sandwich baggie, twist tightly and snip off the tip of the corner. Voila!
• Note: The finished cake is almost 2 feet long so be sure to have it on a large enough cookie sheet or platter!
• Servings vary on how you decide to divide up the body (er, bunny) parts -- .

Steps:

• To make the cake: Preheat the oven to 350 degrees F.
• Butter and flour 1(6-inch) diameter and 1 (8-inch) diameter metal bowls. Combine the cake mix, coconut water, oil, and eggs in another large clean bowl. Beat for 2 minutes, or until well blended. Pour 2 cups of batter into the smaller buttered and floured bowl; pour remaining batter into the larger prepared bowl. Bake the smaller cake for 40 minutes and the larger cake for 45 minutes, or until a toothpick inserted into the center of the cakes comes out clean. Cool the cakes in the bowls on a cooling rack for 30 minutes. Invert the cakes onto the cooling rack and cool completely.
• To decorate: Cut the larger cake in half, forming 2 half-moon pieces. Spread 1/4 cup of frosting over the flat top of each piece. Place the pieces cut side down on a work surface, adhering the frosted sides together. Trim 1-inch from 1 end of the cake; discard the trimmings. Repeat with the smaller cake. Place the larger cake on a serving platter. Spread 2 tablespoons of frosting over the trimmed end of the smaller cake. Place the trimmed end of the smaller cake against the trimmed end of the larger cake. Spread the remaining frosting over the cakes to cover completely. Sprinkle with all but 1/2 cup of the coconut, pressing to adhere. Brush the melted milk chocolate over both sides of the chocolate chunk cookie halves to coat completely. Sprinkle with the reserved 1/2 cup of coconut; set aside until dry. Press 2 semi-sweet chocolate morsels onto the bunny face for eyes. Using a toothpick, secure the gum drop onto the bunny face for the nose. Using toothpicks, secure the licorice pieces onto the bunny face for the whiskers. Using toothpicks, secure the mini-marshmallows onto the bunny face for the teeth. Make 2-inch-deep cuts atop the bunny head; insert the chocolate cookie halves for ears. Roll large the marshmallows together and secure with a toothpick onto the bunny for a tail.