St Louis Barbecued Pork Steaks Recipes

Steps:

• Preheat grill to medium-low heat.
• Season the pork steaks on both sides with seasoned salt and seasoned pepper. In a large bowl, stir together the vinegar and water, and season with seasoned salt and seasoned pepper to taste.
• Lightly oil the grill grate. Place pork steaks on the grill. Baste steaks with the vinegar mixture on both sides during the first 15 minutes of grilling. Continue to cook steaks to desired doneness, 10 to 15 more minutes. Discard remaining vinegar mixture.

Steps:

• Season the steaks on all sides with the grill seasoning, garlic powder, salt and pepper, and Essence. Grill the steaks over medium high heat until done, about 15-20 minutes, flipping once halfway through.
• Reduce heat to medium. Place steaks in a large aluminum roasting pan. To the pan add equal amounts of barbecue sauce and beer until the steaks are just about covered. Wrap the top of the pan with aluminum foil, place on the grill and close the grill cover.
• Cook for at least 1 1/2 - 2 hours, checking periodically to make sure the liquid hasn't evaporated. If it has, add more beer and barbecue sauce. When the steaks are tender, remove the pan from the grill and carefully plate the hot steaks. Serve with your favorite barbecue fixin's.
• For oven preparation, follow the preparation instructions above, then broil the steaks 6" from the heat source, turning once, until cooked through. Place steaks in a 2" deep, foil-lined baking pan, adding barbecue sauce and beer to almost cover. Cover tightly with foil and finish the pork steaks in a 250°F oven for 2 - 3 hours or until tender.

Steps:

• Set a smoker to 225 degrees F.
• Combine the paprika, black peppercorns, coriander seeds, cumin seeds, garlic powder, onion powder, nutmeg and cayenne in a spice grinder. Process until a fine powder is formed, approximately 30 seconds.
• Pat the ribs dry and turn bone-side up. Trim excess fat and, if one end of the ribs is especially narrow, trim meat and bone to ensure even cooking. Remove the membrane on the underside of the ribs by inserting a rounded utensil, an upside-down spoon works well, between the membrane and the meat at one end of the slab. Carefully work the spoon under the membrane to loosen but not tear. Once enough has been loosened, use a paper towel to hold onto the membrane as you slowly pull it down the slab to remove.
• Sprinkle the ribs on both sides with the salt and brush both sides with the mustard. Sprinkle two-thirds of the spice mixture on the meat side of the ribs and the remaining third on the bone side.
• Once the smoker has reached 225 degrees F, add the wood chips or chunks and the ribs to the smoker.
• Smoke for 4 to 5 hours then test for doneness. There are four criteria that should be met in order for ribs to be done. First, the internal temperature of the meat should be 185 to 190 degrees F. Second, pick up each slab from the center with tongs and it should droop into a u-shape and crack slightly. Third, while holding with the tongs, and bouncing gently, the surface of the ribs should crack slightly. Lastly, the meat should pull easily off the bone but not fall off. If ribs pass all tests, remove them from the smoker and wrap in heavy-duty foil and rest for 15 minutes. If not, continue smoking for 45 minutes to 1 hour and test again until done.

Steps:

• Stir together barbecue sauce, honey, worchestershire sauce, garlic salt and mustard in a small bowl.
• Place steaks on grill about 4" above medium slow coals. Cook about 8 minutes on each side. Brush steaks with sauce and continue cooking 5 minutes more. Turning and brushing with sauce.