Homemade Chocolate Covered Peanut Clusters Recipes

Steps:

• In a heavy saucepan over low heat, cook and stir candy coating and chips until melted and smooth. Cool for 10 minutes; stir in peanuts., Drop by rounded tablespoonfuls onto waxed paper-lined baking sheets. Refrigerate until firm, about 45 minutes.

Steps:

• Place both chips and shortening in small microwave-safe bowl. Microwave at High 1 to 1 1/2 minutes or until chips are melted and mixture is smooth when stirred.
• Stir in peanuts.
• Drop by teaspoons into 1-inch diameter candy or petit four papers. Refrigerate until firm, about 30 minutes. Store tightly covered in refrigerator.

Steps:

• Place almond bark in a slow cooker. Stir occasionally on High until mostly melted, about 2 minutes. Reduce heat to Low. Stir in chocolate chips until mixture is completely dark, about 30 seconds. Add peanuts.
• Drop a spoonful of the peanut clusters onto a parchment paper-lined countertop to test if they are thick and chunky. Mix in more peanuts and chocolate chips if the mixture is too loose and runny.
• Line 4 to 5 baking sheets with parchment paper. Lay spoonfuls of the peanut clusters on top using a melon baller. Allow to harden, about 1 hour.

Steps:

• Combine chocolate chips and peanut butter chips in top of double boiler. Stir frequently over low to medium heat until melted; add peanuts and stir.
• Drop by teaspoon full on wax paper. Allow to cool.

Steps:

• Melt the chocolate chips and butterscotch chips together in a heavy pan, or a double boiler.
• Once melted add in peanuts.
• Use a spoon to make clusters on a piece of wax paper.
• Let set for 4-6 hours.

Steps:

• Melt the chocolate in the top of a double boiler over hot, not simmering, water, stirring frequently with a rubber spatula to ensure even melting. Remove the double boiler from the heat, remove the top pan containing the chocolate, wipe it dry, and set aside briefly. Replace the water in the bottom pan with lukewarm tap water, set the pan of chocolate on top of this, and stir gently to reduce the temperature of the chocolate (10 to 15 minutes). It will begin to get a bit thicker as it cools. If using a thermometer, it should register 95°F.
• Again remove the top pan of chocolate from the water and replace the water in the bottom pan with tap water that is a few degrees warmer than the chocolate. If using the same thermometer to check the temperature of the chocolate and the water, be sure to dry it completely so no water mixes with the chocolate. Set the pan of chocolate over the pan of warm water. The warm water will hold the chocolate at the correct temperature so that it does not cool too fast.
• Stir the peanuts into the chocolate, making sure to thoroughly coat them with chocolate.
• Line a baking sheet with parchment or waxed paper. Spoon out clusters 1 inch in diameter onto the sheet, leaving 1 inch of space between them. Let the clusters set up at room temperature, or chill them in the refrigerator for 15 minutes, then place them in paper candy cups. In a tightly covered container wrapped in several layers of aluminum foil, the clusters will keep for 1 month in the refrigerator or 2 months in the freezer. The clusters are best served at room temperature.
• VARIATION
• Substitute milk chocolate for the bittersweet chocolate.

Steps:

• In a double boiler or metal bowl over hot water, melt candy coating and chocolate chips; stir until smooth. Remove from the heat; stir in peanuts. , Drop by rounded teaspoonfuls onto waxed paper-lined baking sheets. Refrigerate for 10-15 minutes or until set. Store in airtight containers.