Onion Rye Loaf Bread Machine Recipes

Steps:

• Measure ingredients into baking pan in the order recommended by the manufacturer.
• Insert pan into the oven chamber.
• Select Basic Cycle.
• When the baking cycle ends, immediately remove the bread from the pan and place it on a rack.
• Let cool to room temperature before slicing.

Steps:

• To proof your starter, feed it with equal parts of flour and water, cover loosely and let it sit overnight or up to 12 hours (longer proof=sourer flavor).
• At this point, measure out your 2 cups of starter into mixing bowl and proceed with recipe.
• Saute onions in olive oil until they become translucent.
• Remove from heat and add butter, water and salt.
• Cool to lukewarm (85 degrees F) and stir into starter.
• Add the rye flour and mix well.
• Add the white flour gradually, until it is too stiff to mix by hand.
• Turn onto a floured surface and knead in enough remaining flour until dough is satiny.
• Shape into an elongate loaf.
• Place on baking sheet and let rise, covered, in a warm place for 1 to 2 hours, or until about doubled in bulk (rising time will vary according to your starter, but it takes longer than breads made with commercial yeast).
• Preheat oven to 375 degrees F.
• Make diagonal slashes in top of loaf with a razor blade or very sharp knife.
• Bake for 40 to 50 minutes.
• Remove from baking sheet and cool on wire rack.
• This bread could also be made using the dough cycle of your bread machine.

Steps:

• Put lukewarm water, milk powder, salt, brown sugar, molasses, butter, whole wheat flour, bread flour, rye flour, caraway seeds, and yeast into the pan of a bread machine in the order suggested by the manufacturer. Select the Grain setting and 2-pound loaf size.

Steps:

• Place ingredients except seeds and onion flakes in bread machine according to the instructions of your machine. Mine calls for wet ingredients first so I listed them in order to be placed into the machine. Be sure to place the salt and yeast in separate corners.
• Set machine on the dough cycle. Place seeds and onion flakes in when machine beeps during the end of kneading.
• Lightly oil large baking pan.
• When dough cycle is finished remove dough to a floured work surface. Divide into two. Roll out into a 1 inch disk. Fold one side in to center pressing with rolling pin, then the other half fold to center pressing inches Then fold at center line pressing seams to seal. Roll the loaf forward and back to form a 12 inch loaf. Repeat with the other 1/2 of the dough.
• Place both on the pan leaving room for them to raise. Cover with oiled plastic wrap. Place in a warm draft free place for 45 minutes.
• Remove wrap dust with flour and score the loafs Leave to stand for ten minutes while you preheat oven to 425 degrees.
• Bake for 20 minutes.
• It will sound hallow when you tap on the bottom which will be dark.
• Cool on wire rack.

Steps:

• Place ingredients in the bread maker pan in the order listed.
• Process on the whole wheat cycle.

Steps:

• Grease a 9x5-in. loaf pan and sprinkle lightly with cornmeal; set aside., In a large bowl, combine 1 cup all-purpose flour, rye flour, onion, sugar, caraway, salt and yeast. In a small saucepan, heat the milk and butter to 120°-130°. Add to dry ingredients; beat just until moistened. Stir in enough remaining all-purpose flour to form a firm dough., Turn onto a floured surface; knead until smooth and elastic, about 6-8 minutes. Place in a greased bowl, turning once to grease the top. Cover and let rise in a warm place until doubled, about 1 hour. , Punch dough down. Shape into a loaf. Place in prepared pan. Cover and let rise until doubled, about 30 minutes. Combine egg white and water; brush over loaf. Bake at 350° for 40-45 minutes or until golden brown. Remove from pan to a wire rack to cool completely.

Steps:

• In 10-inch skillet, melt butter over medium-low heat. Cook onions in butter 10 to 15 minutes, stirring occasionally, until onions are brown and caramelized; remove from heat.
• Measure carefully, placing all ingredients except onions in bread machine pan in the order recommended by the manufacturer. Add 1/2 cup of the onions at the Raisin/Nut signal or 5 to 10 minutes before last kneading cycle ends. (Reserve any remaining onions for another use.)
• Select Basic/White cycle. Use Medium or Light crust color. Do not use delay cycle. Remove baked bread from pan; cool on cooling rack.

Steps:

• Melt butter in skillet over medium-low heat. Cook onions in butter 10 to 15 minutes, stirring occasionally, until onions are brown and caramelized. Do not hurry the process. Remove from heat.
• Place all remaining ingredients in bread machine pan in the order recommended by the manufacturer.
• Set to basic cycle with medium or light crust. Add onions at beep signal or 5 to 10 minute before end of kneading cycle.
• Alternatively, use dough cycle. Remove dough at end of cycle, shape as desired, place on cornmeal-sprinkled baking sheet and let rise. Bake for app. 30 to 40 minutes in a 400 deg. oven. Exact time depends on shape.
• Note: I generally substitute one cup of whole wheat or rye flour for one cup of the bread flour. Rye is particularly excellent.