Serviettenapkin Folding Informal Drop And Tie Recipes

Steps:

• Lay your serviette square out flat before you.
• Fold the top and bottom left hand edges to meet the top and bottom right hand edges. You will have a long rectangle with the fold on the left hand edge.
• Fold the bottom short edge up about 1/3 of the way up the rectangle. Then repeat another 1/3 of the way up.
• Carefully turn the serviette over and fold the top and bottom East edge to the centre.
• Repeat with the West edge.
• Carefully turn this over again and you will have a neat package that has a pocket at the bottom into which a nametag, cutlery, flowers or a small gift can be inserted.

Steps:

• Lay your serviette out flat before you in a diamond shape.
• Take your finger and place it half way between the West and South points, and about 1 inch toward the centre of the serviette. Next, Take the East point at bring it to the point where your finger is. Don't crease this fold (yet).
• Now take the West point of the serviette and bring it over to the East side so that both sides of this new diamons shape are even. Youmay have to adjust the first fold a little to get it looking good, once they are both ok, you can crease both the folds.
• You will have a very fat tie shape.
• Repeat the previous step again completely and you will have a smaller tie shape in front of you now.
• Take the top third of the tie (the narrowest bit) and fold it under and over itself horizontally (the end tip should be tucked undernieth) and the top should now look like the knot of a formal neck tie.
• Place on a plate and surprise the men in your life!

Steps:

• Lay your serviette square out flat before you in a diamond shape.
• Fold the North point of the diamond down to meet the South point of the diamond. You will now have a triangle shape that's pointing downwards.
• Take hold of the South points and start rolling them up towards the North point, stopping fractionally short of the crease at the top.
• Loop the right hand end over the left hand end, pull the right hand end though the resulting hole to form a loose knot.
• Don't pull the knot too tight, just enough to be pleasing and informal.

Steps:

• Take your square napkin, lay it totally flat before you, then fold it in half horizontally.
• Fold again, this time vertically so that you have before you a square a quarter the size of your origonal square.
• Only one of the 4 corners will have 4 open or loose edges. Rotate the square before you so that it looks like a diamond with the four open edges pointing to the bottom.
• We will call the points on your diamond shape East, West, North and the open egded bit, South.
• Make a horizontal fold between the East/West points, bringing the open ended South point up to meet, and on top of, the North point.You will now have a little triangle.
• Take the East point of the triangle and fold it in towards the middle. What was the sloping right hand edge of the triangle is now a vertical edge running down the center of the triangle and there is a little flap sticking out at the bottom.
• Take the West point and fold it into the center the same as you did with the previous East edge, the two vertical lines should meet in the middle, and you will have a diamond shape that has two long sides at the top and two short sides (the two little flaps) at the bottom.
• Pick up your diamond shape and fold the two little flap bits at the bottom completely under, so that they only show on the back of the triangle. The front will now look like a steep triangle with a vertical slit down the middle.
• We will call the points of this triangle East, West and North. With the flaps still folded to the back of the tiangle, fold the East and West points backwards until they meet, and gently crease the two folds that form and meet at the North point.
• The slit in the front will have opened and the 4 open points of the napkin will be hidden in layers inside. Pull very gently on them one by one and they will stand up like the sails of a boat. Some people I know call this napkin a boat, some a flower and some the Sydney Opera House.I don't know its' offical name but set onto a plate or into an empty wine glass, this a very elegant addition to a classy table setting.

Steps:

• Lay your serviette square out flat before you. Fold it in half horizontally.
• Take the serviette and fold it in half again vertically so that it is now a small square a quarter the size of the origonal square.
• Only one corner of the square will have 4 open / loose edges, rotate your square so that it is a flat diamond shape with the open corner pointing downwards. We will call this the South corner, and the top corner opposite North.
• Grasp your serviette about 2/3 of the ways up and starting at point that is on the East side of your serviette, make 5 folds or pleats more or less the same size, folding/ pleating towards from the East point to the West point.
• Slip your Serviette Ring over the north point and gently pull downwards so that only the top 1/3 of the serviette goes though the ring. Keep the north point of the serviette nicely centered.
• Spread the bottom half out the serviette into a fan formation so that both halves are equal and it looks pleasingly balanced.The top of the serviette should taper gently up to the North point and if wanted a small flower can be inserted into the fold at the top and down into the napkin ring.
• Place on empty plate.

Steps:

• Lay your serviette square out flat before you in the shape of the square.
• Fold the bottom left and right corners up to meet the top left and right corners so that you now have a rectangle shape with the crease at the bottom.
• Take the top and bottom right corners and roll them all the way to the left top and bottom corners.
• Slip the serviette ring over the rolled end and bring up to the half way point. Set the serviette on a plate with the join at the back and the closed neat part of the roll facing the top.

Steps:

• Lay your serviette square out flat before you. Fold it in half horizontally.
• Take the serviette and fold it in half again vertically so that it is now a small square a quarter the size of the origonal square.
• Only one corner of the square will have 4 open / loose edges, rotate your square so that it is a flat diamond shape with the open corner pointing downwards. We will call this the South corner, and the top corner opposite North.
• Take the uppermost of the loose points at the South position and fold it up to meet the North point.
• Take the next loose point at South position and also fold it towards the north point but stop short of it so that you have a triangle within a triangle.
• Repeat with the remaining two loose points so that you now have a set of ever decreasing triangles on the front of your triangular serviette. If you have time, press these with an iron so that you have crisp sharp creases ( this does improve the result immensely).
• Carefuly turn the serviette over and take the bottom right point and bring it up to a central point midway along the edge between the bottom left point and the top at North.
• Repeat with the remaining corner. Iron the creases.
• Turn the serviette over again to show off the neat front side.