Spaghetti With Garlic And Chilli Recipes

Steps:

• Heat 1 tbsp oil in a pan, add the mushrooms, then fry over a high heat for 3 mins until golden and softened. Add the garlic, fry for 1 min more, then tip into a bowl with the parsley. Add the onion and celery to the pan with the rest of the oil, then fry for 5 mins until lightly coloured.
• Stir in the tomatoes, chilli and a little salt, then bring to the boil. Reduce the heat and simmer, uncovered, for 10 mins until thickened. Meanwhile, boil the spaghetti, then drain. Toss with the sauce, top with the garlicky mushrooms, then serve.

Steps:

• Bring a large pot of salted water to a boil. Cook the pasta according to package instructions. Save ¼ cup (60 ml) of pasta water, then drain.
• Add the olive oil and garlic to a large cold sauté pan. Turn the heat to medium-low and slowly heat up until the garlic is fragrant and lightly colored, about 3 minutes.
• Add the chile flakes and cook for another minute.
• Add the reserved pasta water and bring to a simmer. Add the cooked spaghetti and parsley, if using. Stir until the pasta is well-coated. Season with salt to taste.
• Enjoy!

Steps:

• Bring a large pot of lightly salted water to a boil. Place spaghetti in the pot, cook for 8 to 10 minutes, until al dente, and drain.
• In a large bowl, toss the spaghetti with the olive oil, butter, garlic, basil, salt, and pepper until evenly coated. Serve with Parmesan cheese.

Steps:

• Cook pasta in boiling, well-salted water, following package directions to avoid overcooking.
• While pasta is cooking, heat olive oil over medium-low heat in a large skillet and add garlic, cooking gently until garlic is soft.
• Remove from heat and stir in crushed chile pepper.
• The moment the pasta is ready, drain, reserving about 1 cup of the cooking water, and add pasta to skillet.
• Toss with oil and garlic until well mixed, adding some of the cooking water if pasta seems too dry.
• Add parsley and toss again. Correct seasoning and serve immediately.

Steps:

• Bring a large pot of water to a boil. Season generously with salt. Stir in spaghetti and cook until slightly less than al dente, about 2 minutes less than package directions. Reserve 1 cup pasta water; drain.
• Meanwhile, add garlic and oil to a cold large skillet over medium heat. Cook, stirring occasionally, until garlic is just golden, 2 to 3 minutes. Add sage and chile; cook 1 minute more. Stir in 1/2 cup pasta water and a few grinds of pepper. Increase heat to high and cook, swirling skillet occasionally, until reduced by about half, 2 to 3 minutes. Add pasta; toss to coat.
• Remove skillet from heat, add cheese, and toss vigorously, adding more pasta water as needed to create a creamy sauce. Season with salt and pepper and serve, with basil leaves and more cheese scattered over top.