Banh Mi Baby Back Ribs Recipes

Steps:

• In a small bowl, combine the brown sugar, chipotle chile powder, salt, onion powder, garlic powder, seafood seasoning and black pepper.
• Place each slab of ribs on a piece of aluminum foil large enough to fold over and seal, then place on a baking sheet. Do not seal the ribs in the foil yet (see Cook's Note). Generously sprinkle the dry rub on both sides of the ribs. Place in the refrigerator, meat-side down and uncovered, for at least 1 hour. Preheat the oven to 300 degrees F.
• In a small bowl, combine the apple cider, apple cider vinegar, maple syrup, Worcestershire and minced garlic. Pour half the liquid over each slab and tightly seal each in the aluminum foil, crimping the edges to make a packet.
• Transfer the foil packets and baking sheet to the oven and bake until the meat is tender and starts to pull away from the bones, about 2 hours.
• Remove the sheet pan from the oven. Carefully open the aluminum packets and pour the braising liquid into a small saucepan. Bring the liquid to a simmer over medium heat until it becomes a thick and syrupy glaze, about 4 minutes.
• While the braising liquid reduces, line a baking sheet with foil and gently transfer the ribs to it. Position a rack on the top level of the oven and preheat the broiler.
• Using a pastry brush, generously brush the ribs with about half the glaze. Place the ribs under the broiler for about 1 minute. Brush with the remaining glaze and return to the broiled until charred in spots, about 1 minute more. Slice each rack between the bones into 2-rib portions and serve.

Steps:

• Preheat oven to 250 degrees F (120 degrees C).
• Mix ancho chile powder, white sugar, brown sugar, salt, black pepper, cumin, dry mustard, cayenne pepper, and chipotle pepper in a small bowl until combined.
• Place ribs meat-side down on aluminum foil. Prick back of rib rack several times with a knife.
• Generously apply coating of dry rub to all sides of rib rack.
• With rib rack meat-side down, fold foil around it to create a tight seal. Transfer to sheet pan.
• Bake in preheated oven until tender and cooked through, about 2 hours. Remove and cool 15 minutes.
• Increase oven temperature to 350 degrees F (175 degrees C).
• Open foil, drain and discard any accumulated juices and fat. Brush barbeque sauce on all sides of rack.
• Place rack meat-side up and return to oven, leaving foil open. Bake for 10 minutes, remove from oven, and brush another layer of barbeque sauce on meat-side only. Repeat baking and brushing with sauce 4 more times, for a total of 50 minutes baking time.
• Cut rack into individual rib segments and serve with more barbeque sauce.

Steps:

• Build a fire in your grill; when the coals are all covered with gray ash and the temperature is medium-low (you can hold your hand 5 inches above the coals for 7 seconds), you're ready to cook. (For a gas grill, turn all burners to high, lower cover and heat for 15 minutes, then turn burners to medium-low.)
• Sprinkle the ribs generously with salt and pepper, place them on the grill directly over the coals, and cook until a peek inside shows that the meat no longer has any pink at the center, about 10 to 12 minutes per side.
• When the rib racks come off the grill, cut them into individual ribs and place in a large bowl. Add all the remaining ingredients, toss to coat, season with more salt and pepper if needed, and serve.

Steps:

• Grilling Method: Indirect/Medium-Low Heat
• Build charcoal fire or preheat gas grill. Remove silver skin from back of ribs, if desired. Set up the grill for indirect heat and if using wood chips, place soaked chips directly on charcoal, or in smoking box of gas grill. Rub the cut lemons over front and back of ribs squeezing to release as much juice as possible. Set aside for 5 minutes. Rub ribs liberally with Classic Barbecue Rub and let sit, covered, for 15 to 20 minutes.
• Place ribs (bone side down) in the center of the cooking grate or in a rib holder/rack, making sure they are not over a direct flame. Grill covered (at about 325°F, if your grill has a thermometer) for 1 1/2 to 2 hours or until meat is tender and has pulled back from the ends of the rib bones.
• Leave ribs untended for the first 30 minutes-this means no peeking; especially important if using wood chips. If the ribs start to burn on the edges, stack them on top of one another in the very center of the grill and lower your fire slightly. Twenty minutes before serving, un-stack ribs, if necessary and brush with barbecue sauce. Remove ribs from grill and let rest 10 minutes before cutting into individual or 2 to 3 rib portions. Warm remaining sauce in a saucepan and serve on the side, if desired.

Steps:

• The Rainford Method
• For the ribs, stir together the sugar, salt, smoked paprika, chili powder, regular paprika, onion powder, black pepper and thyme. Set aside.
• With a small, sharp knife, release the edge of the membrane on the back of each rack of ribs. Grasp the edge with needle-nose pliers or a piece of paper towel and peel the membrane off the rack. (If you leave the membrane on, the ribs will be chewy.)
• Spread the dry rub all over each rack of ribs until completely coated. Make sure you press the dry rub into the meat. This is where your flavor is going to come from. Arrange the ribs in a rib rack, with all the racks facing the same direction. A rib rack has 8 slab compartments, looks like a rack of coat hangers and can be purchased at most barbecue stores.
• Fire up your charcoal grill and prep the grill for cooking over indirect heat. You need a low temperature of around 250 to 300°F (120 to 150°C) to grill the ribs. For gas grills, preheat the grill to low then turn off one side of the grill to achieve indirect heat. Place a drip tray on the cooler side of the grate and half fill the pan with warm water or the beer of your choice.
• Drain 2 chunks of hickory, place them on top of the charcoal and set the grate in place. For gas barbecues, place half of the hickory chips in a foil pouch and place the pouch directly on the heated side of the grill. Wait for the hickory to start to smoke.
• Place the rib racks over indirect heat as far from the heat as possible, with the bone sides facing toward the heat. Close the lid and close the top vent on a charcoal grill about halfway. This will maintain a temperature between 250 and 300°F (120 and 150°C). Cook the ribs for 2 hours.
• Once the ribs are on, it's time to start working on the barbecue sauce. If you have a side burner this can be done outside. If you don't, go inside and use your stove top to simmer your sauce. Combine all the ingredients in a small saucepan set over medium heat. Simmer for 20 to 30 minutes or until the sauce reaches a glaze consistency. Remove the saucepan from the heat and set aside to cool.
• The first batch of charcoal should be cooling down after 2 hours. Now is the time to use your chimney starter and get another batch of charcoal lit. Add the remaining wood chunks to the coals to get a little more smoke. If using a gas grill, wrap the remaining chips in foil and place directly on the hotter side of the grate. Close the lid and grill for another 2 hours. Make sure to come back every hour on the hour to check the temperature and to add more charcoal, if necessary. In the last hour of grilling, your ribs will start to show signs of cooking all the way through. When the meat pulls back from the bone, the ribs are almost ready. Baste the ribs with the barbecue sauce during the last 5 to 10 minutes of cooking. I like to tent my ribs before serving, so take them off the grill and let them rest, loosely covered with foil, for 10 minutes.

Steps:

• Place ribs in a greased roasting pan. Bake, uncovered, at 350° for 45 minutes. Meanwhile, in a saucepan, combine the remaining ingredients. Bring to a boil; cook for 1 minute. Drain ribs. Spoon sauce over ribs. Cover and bake for 1-1/2 hours. Uncover; bake 30 minutes longer, basting once.

Steps:

• Preheat a gas grill for high heat, or arrange charcoal briquettes on one side of the barbeque. Lightly oil the grate.
• In a small jar, combine cumin, chili powder, paprika, salt, and pepper. Close the lid, and shake to mix.
• Trim the membrane sheath from the back of each rack. Run a small, sharp knife between the membrane and each rib, and snip off the membrane as much as possible. Sprinkle as much of the rub onto both sides of the ribs as desired. To prevent the ribs from becoming too dark and spicy, do not thoroughly rub the spices into the ribs. Store the unused portion of the spice mix for future use.
• Place aluminum foil on lower rack to capture drippings and prevent flare-ups. Lay the ribs on the top rack of the grill (away from the coals, if you're using briquettes). Reduce gas heat to low, close lid, and leave undisturbed for 1 hour. Do not lift the lid at all.
• Brush ribs with barbecue sauce, and grill an additional 5 minutes. Serve ribs as whole rack, or cut between each rib bone and pile individually on a platter.