Halloween Chocolate Lollipops Recipes

Steps:

• The mold shapes used were bats, witches, gravestones, ghosts and skulls. You can use any molds to make chocolate lollipops.
• To make the lollipop: Pour any of the tempered chocolates directly into the molds, filling them to the top. Tap the molds against the work surface to release the air bubbles. Set the sticks in place by inserting them just far enough to be secure within the mold you are using. Set the molds aside to allow the chocolate to set. When set, simply pop out the lollipops.
• If you do not have any lollipop molds, you can use Play-Doh modeling clay to make your own molds. Roll fresh Play-Doh into a 1/2-inch-thick rectangle on top of a sheet of parchment paper. Use a sharp paring knife to cut shapes from the Play-Doh. Remove the cutout leaving the homemade mold. Spray the inside edge of the Play-Doh with vegetable cooking spray. Pour the chocolate into the cutout space. Insert the lollipop sticks and let cool completely before removing the Play-Doh. When finished, the Play-Doh can be saved and reused for another day.

Steps:

• If desired, add nuts to any or all of the chocolates. Pour the chocolate into the molds, filling them to the top. Set the sticks in place by inserting them just far enough to be secure within the mold you are using. Set the molds aside to allow the chocolate to set. When set, simply pop out the lollipops. If you are using molding compound, roll it into a 1/2-inch-thick rectangle on top of a sheet of parchment paper. Using a sharp paring knife, cut out whatever shapes you would like and remove the cutout, leaving the homemade mold. Spray the inside edge of the molding compound with vegetable cooking spray and pour the chocolate into the cut out space. Insert the lollipop sticks and let cool completely before removing the molding compound. When finished, the molding compound can be saved and reused for another day.
• How to Temper Chocolate (From Dessert Circus, Extraordinary Desserts You Can Make At Home by Jacques Torres): Chocolate is tempered so that after it has been melted, it retains its gloss and hardens again without becoming chalky and white (that happens when the molecules of fat separate and form on top of the chocolate). There are a variety of ways to temper. One of the easiest ways to temper chocolate is to chop it into small pieces and then place it in the microwave for 30 seconds at a time on high power until most of the chocolate is melted. Be very careful not to overheat it. (The temperature of dark chocolate should be between 88 and 90 degrees F, slightly warmer than your bottom lip. It will retain its shape even when mostly melted. White and milk chocolates melt at a temperature approximately 2 degrees F less because of the amount of lactose they contain.) Any remaining lumps will melt in the chocolate's residual heat. Use an immersion blender or whisk to break up the lumps. Usually, chocolate begins to set, or crystallize, along the side of the bowl. As it sets, mix those crystals into the melted chocolate to temper it. A glass bowl retains heat well and keeps the chocolate tempered longer. Another way to temper chocolate is called seeding. In this method, add small pieces of unmelted chocolate to melted chocolate. The amount of unmelted chocolate to be added depends on the temperature of the melted chocolate, but is usually 1/4 of the total amount. It is easiest to use an immersion blender for this, or a whisk. The classic way to temper chocolate is called tabliering. Two thirds of the melted chocolate is poured onto a marble or another cold work surface. The chocolate is spread out and worked with a spatula until its temperature is approximately 81 degrees F. At this stage, it is thick and begins to set. This tempered chocolate is then added to the remaining non-tempered chocolate and mixed thoroughly until the mass has a completely uniform temperature. If the temperature is still too high, part of the chocolate is worked further on the cold surface until the correct temperature is reached. This is a lot of work, requires a lot of room, and makes a big mess. A simple method of checking tempering, is to apply a small quantity of chocolate to a piece of paper or to the point of a knife. If the chocolate has been correctly tempered, it will harden evenly and show a good gloss within a few minutes.

Steps:

• Line three baking sheets with Silpats (nonstick baking mats), or grease them generously with vegetable oil. Prepare an ice-water bath. Combine sugar, corn syrup, and 1/4 cup water in a small saucepan, and place over medium-high heat. Stir continuously to dissolve sugar. When the syrup comes to a boil, stop stirring and clip on a candy thermometer. Continue to cook, without stirring, until the mixture turns golden and reaches 300 degrees to 310 degrees. (hard-crack stage) on the thermometer, 5 to 7 minutes. Occasionally wash the sides of the pan using a clean brush dipped in cold water to prevent crystals from forming.
• Remove the pot from the heat. Transfer the syrup to a 2-cup heatproof measuring cup. Using a heatproof rubber spatula, stir in the food coloring and orange oil until completely combined.
• Working quickly, pour ten 3-inch circles of syrup onto prepared baking sheets. Press in lollipop sticks. With your fingertips or a toothpick, lightly press candies into the syrup. Set aside until completely cooled and hardened.

Steps:

• Preheat oven to 350°. In a large bowl, beat butter and sugar until blended. Beat in eggs and vanilla. In a small bowl, whisk flour, cocoa, baking powder, baking soda and salt; gradually beat into sugar mixture. Shape dough into 1-1/2-in. balls. Place 3 in. apart on greased baking sheets., Insert a lollipop stick into each cookie. Flatten with a glass dipped in sugar. Bake 10-12 minutes or until cookies are set. Remove from pans to wire racks to cool completely. Tint frosting; frost cookies. Decorate with gel and optional decorations as desired.