Larrys Smoked Bbq Spare Ribs Recipes

Steps:

• Prepare an indirect fire with charcoal in a smoker or grill, according to manufacturer's instructions. Once the coals get going, add wood chips. Maintain a temperature of 230 to 260 degrees F (110 to 127 degrees F).
• Meanwhile, mix paprika, brown sugar, garlic powder, salt, and pepper together in a bowl until well combined. Spread rub all over ribs, making sure not to miss any spots.
• Place ribs on the preheated smoker or grill on the opposite side of the fire. Cover and smoke ribs, adding wood chips as needed to maintain temperature, until rub has set and looks dry, 1 to 2 hours. Baste with apple juice and continue to cook, basting every 30 minutes, for 2 1/2 to 3 1/2 hours more.
• Brush BBQ sauce on both sides of the ribs, and cook for 15 minutes. Brush again, and cook until meat pulls away easily from the bone, 10 to 15 minutes longer. An instant-read thermometer inserted into the center should read 145 degrees F (63 degrees C).

Steps:

• Place pork rib slab flat on a clean chopping board. Pull off membrane. Cut off the excess fat and meat. Season both sides of the slab with Neely's BBQ Seasoning. Refrigerate for at least 24 hours.
• Preheat your grill at 275 degrees F, using hickory wood and charcoal.
• Place the slab on the grill away from the flame, using indirect heat. Cook the slab for approximately 2 1/2 hours with the curl side up. Flip the slab over to finish cooking for approximately 1 hour or until you get full "bend" in the slab.
• For dry ribs: Pull ribs off grill, sprinkle Neely's BBQ Seasoning over entire slab. Cut between the bones and serve.
• For wet ribs: Pull ribs off grill, pour Neely's BBQ Sauce over slab. Cut between the bones and serve.
• Mix all the ingredients and set aside.
• Combine all of the sauce ingredients in a stockpot or large Dutch oven. Bring to a boil over high heat, stirring frequently to prevent sticking. Reduce temperature to low and simmer, uncovered, for at least 2 hours.

Steps:

• Prepare ribs:.
• Let the ribs come up to room temperature, rinse off in cold water and remove the silver membrane from the back. You don`t have to remove it but I find the membrane blocks the uptake of smoke and creates a barrier to your rubs.
• To remove the membrane, lay the ribs on a flat surface meat side down. Take a sharp knife and begin peeling the membrane from one corner near the bone. Once you have a good piece peeled back, grab it with a paper towel to get a good grip and begin pulling. Once the membrane is removed rinse off the ribs again and pat dry with some paper towels.
• Mustard Rub:.
• Mix rub mixture together.
• Then rub the mustard rub mixture over the entire surface of the ribs.
• Once the pork ribs are seasoned and the smoker is ready then you are set to go. Using a blend of oak, hickory and a little mesquite in the firebox,or what you prefer.
• Place the ribs in the smoker and let it go. You want the good smoking temperature in the area about 200 degrees. You can go lower if you plan on doing a long smoke, but I don't go higher.
• After smoking for 2 hours. Then wrap the ribs in heavy duty foil and keep going for 2 more hours. Creating fall off the bone ribs! Then unwrap for one hour.
• To serve I cut the ribs inIf you want crispy ribs blast the heat on the grill and char them.
• If you want extra sweet, spicy, sticky goodness dip into your favorite BBQ sauce. Apply the sauce when the foil comes off, but for crispy ribs apply after crisping. If you want extra smoke go ahead and add more wood when unwrapping the ribs.
• Let ribs sit for 10 minutes before cutting into servings.

Steps:

• In a Dutch oven, place ribs and onion; sprinkle with salt and pepper. Add enough water to cover ribs; bring to a boil. Reduce heat; cover and simmer for 1-1/2 hours or until meat is tender; drain. , Meanwhile, in a small saucepan, combine sauce ingredients. Simmer, uncovered, for 1 hour or until slightly thickened, stirring occasionally. , Arrange ribs on a rack in a broiler pan. Brush with sauce. Broil 5 in. from the heat for 5 minutes on each side, brushing frequently with sauce.

Steps:

• Combine all of the spices with the sugar and blend well forming a BBQ spice mix to use as a rub.
• Trim the ribs of any excess fat and remove the membrane from the back of the ribs.
• Season the ribs all over with the spice mix.
• Place ribs bone side down in an enclosed (covered) smoker preheated to 230 degrees Fahrenheit.
• Turn the ribs and baste with apple juice every hour for 4 to 5 hours, or until you can take two side by side ribs and tear them apart easily.
• During the last 30 minutes of smoking you will need to start glazing the ribs on both sides with BBQ sauce of your choice, every 10 minutes (3 times in total).
• Remove the ribs from the smoker, cover and let rest for 10-15 minutes; serve hot.

Steps:

• Prepare an indirect fire with charcoal in a smoker or grill, according to manufacturer's instructions. Once the coals get going, add wood chips. Maintain a temperature of 230 to 260 degrees F (110 to 127 degrees F).
• Meanwhile, mix paprika, brown sugar, garlic powder, salt, and pepper together in a bowl until well combined. Spread rub all over ribs, making sure not to miss any spots.
• Place ribs on the preheated smoker or grill on the opposite side of the fire. Cover and smoke ribs, adding wood chips as needed to maintain temperature, until rub has set and looks dry, 1 to 2 hours. Baste with apple juice and continue to cook, basting every 30 minutes, for 2 1/2 to 3 1/2 hours more.
• Brush BBQ sauce on both sides of the ribs, and cook for 15 minutes. Brush again, and cook until meat pulls away easily from the bone, 10 to 15 minutes longer. An instant-read thermometer inserted into the center should read 145 degrees F (63 degrees C).

Steps:

• Place in a single layer in a 15x10x1-in. baking pan. Bake at 325° for 30-35 minutes; drain. , In a large saucepan, combine the remaining ingredients. Bring to a boil. Pour over ribs. Bake 50-60 minutes longer, basting occasionally. Cut into serving-size pieces.