Reverse Sear Prime Rib Roast Recipes

Steps:

• Remove the roast from the refrigerator 2 or 3 hours before cooking.
• Preheat oven to 450.
• Rub butter on the cut ends of the roast.
• Combine flour, salt and pepper together in a small bowl, and then massage the mixture all over the meat.
• Set the roast, rib side down, in a shallow roasting pan (the ribs act as a natural rack), and place in the oven. Roast for approximately 20 to 30 minutes, or until the roast is nicely darkened. Reduce oven to 350 and continue to roast, basting every 15 or 20 minutes, until the roast reaches an internal temperature of 125 degrees (for medium-rare) on an instant-read thermometer. Remove the roast to a cutting board and let rest for 20 minutes before carving into either huge slabs or off the bone entirely and then thin slices.

Steps:

• Make 4 evenly spaced small slits about 1/2 inch deep on the top of the roast with a small paring knife. Put a few rosemary leaves on top of each slit and push them in using a piece of garlic. Repeat on the other side of the roast. Make two slits on the ends of the roast and stuff with the remaining rosemary and garlic.
• Combine 5 teaspoons salt and 1 tablespoon pepper in a small bowl and stir to combine. Sprinkle all over the roast, firmly pressing the mixture onto the exterior and stuffing some into the slits.
• Place the trivet in the bottom of the insert of a 6-quart Instant Pot®. Pour in the beef broth and 1/4 cup of the wine. Place the roast on the trivet, fat-side up, then set it to pressure cook on low for 10 minutes with the keep warm feature turned on (see Cook's Note). Once the pressure cook cycle ends let the pot stand, closed, for 45 minutes. Open the lid and transfer the roast to a plate. Remove the trivet and pour the broth into a heatproof container. Rinse the insert and return it to the machine.
• Set the machine to sauté and add the butter. Once the butter is melted and foamy add the roast and sear until dark brown on all sides and an instant-read thermometer inserted into the center of the roast registers 120 degrees F for medium rare, about 4 minutes per side. Transfer the roast to a cutting board and let rest for 15 minutes before slicing.
• Meanwhile, immediately add the remaining 1/4 cup wine to the insert, scraping up the browned bits that are stuck to the bottom. Continue to cook until almost all the wine has evaporated then sprinkle in the flour. Stir until a uniform paste forms then whisk in the reserved broth. Bring to a boil and simmer until the flavor of the flour has cooked out, about 5 minutes. Adjust the seasoning, if needed, and whisk in a bit more beef broth if the gravy becomes too thick. Strain through a mesh strainer into a gravy boat and stir in the herbs right before serving. Serve alongside the roast.