Bread Machine French Style Bread Recipes

Steps:

• Add 3/4 cup water, salt, flour, parmesan cheese, garlic powder and yeast to bread machine pan in order suggested by manufacturer.
• Select dough/manual cycle.
• When cycle is complete, remove dough from machine to a lightly floured surface.
• Roll dough into a 15x10 inch rectangle.
• Beginning at long end, roll up tightly as for jelly roll.
• Pinch seams and ends to seal.
• Taper ends by gently rolling back and forth.
• Place loaf, seam side down on a greased baking sheet sprinkled with cornmeal.
• Lightly brush loaf with oil.
• Cover and let rise in warm draft-free place until almost double in size, 10 to 15 minutes.
• With a sharp knife, make 3 or 4 diagonal cuts about 1/4 inch deep across the top of loaf.
• Lightly beat egg white and 1 tablespoon water; brush some of egg white mixture over top of loaf.
• Bake at 375 for 20 minutes.
• Brush again with remaining egg white mixture and sprinkle with sesame seeds.
• Bake 5 to 10 minutes more or until done- bread should sound hollow when tapped.
• Remove the bread from the baking sheet and cool on a wire rack.

Steps:

• Place ingredients in bread machine according to manufacturers directions.
• Start machine on dough setting.
• When dough cycle is complete, remove dough with floured hands and cut in half on floured surface.
• Take each half of dough and roll to make a loaf about 12 inches long in the shape of French bread.
• Place on greased baking sheet and cover with a towel.
• Let rise until doubled, about 1 hour.
• Preheat oven to 450°.
• Bake for 15 to 20 minutes or until golden brown, turning pan around once halfway during baking.
• Remove baked loaves to wire racks to cool.

Steps:

• Measure ingredients into baking pan in order listed.
• Black& Decker Setting 6 (Specialty- French 3H 30M cycle).

Steps:

• put in machine in order and push buttons to make a 1.5 Lb french loaf.

Steps:

• Put the ingredients in the machine in the order listed.
• From time to time, check the dough.
• If too dry add water, if too wet add flour, always one tsp at a time.

Steps:

• Add Water to your bread machine first, then add the sugar, salt, flour and yeast. Put it on your dough cycle. Check consistency of dough during cycle as you may need to add a little water or flour depending on your bread maker. When complete, roll dough out to a 12in long loaf of bread and allow to rest on a lightly floured baking sheet covered by a towel for 1 hour. With a knife cut three diagonal slashes across the top of the bread and then glaze. Bake in a preheated oven at 400F/205C for 15 to 20 minutes or until done. Allow to cool on wire tray, then enjoy.

Steps:

• Add the ingredients to the bread machine per your bread machine instructions.
• Use the French Bread cycle, medium crust, and 1 pound loaf.
• Remove when done and cool before slicing.