Bread Machine Wheat Bread Recipes

Steps:

• In bread machine pan, place all ingredients in order suggested by manufacturer. Select basic bread setting. Choose crust color and loaf size if available. Bake according to bread machine directions (check dough after 5 minutes of mixing; add 1 to 2 tablespoons of water or flour if needed).

Steps:

• Place ingredients in the order given in bread machine bucket.
• Process on basic/white cycle, medium color crust setting.
• I use warm (tepid) water and the rapid (3 hr) setting.
• You can use 1 1/2 teaspoons yeast, but I've found that 2 teaspoons produces a fluffier loaf.

Steps:

• Follow directions for your machine for a 2-pound loaf of whole wheat bread.
• Instructions for my machine are: Add all ingredients in the order listed. (I combine the water and powdered milk and heat them in microwave on high for 30 seconds before putting in baking pan and then add the remaining ingredients.).
• Insert the baking pan into the oven chamber and lock the pan.
• Select Whole Wheat setting and 2 pound loaf.
• Press start.
• When the baking is finished, I like to put the loaf in a large zip lock bag and seal it. Then place on wire rack to cool completely before slicing.

Steps:

• 1. Combine yeast, honey, and 1¼ cups (300 ml) warm water and set aside to proof, about 5 minutes.
• 2. When starting with whole kernel wheat: Place wheat, and if desired, salt into the Vitamix Dry Grains Container and secure lid. Select Variable 1. Turn machine on and slowly increase speed to Variable 10, then to High. Grind wheat for 1 minute. (Do not over process) Stop the machine and allow the flour to cool for a few minutes.
• 3. When starting with whole wheat flour: Place flour and, if desired, salt into the Vitamix Dry Grains or Standard Container and secure lid.
• 4. Select Variable 1.
• 5. Turn machine on and slowly increase speed to Variable 6. Blend until a hole forms in the center of the mixture, about 5 seconds. Turn machine off and remove the lid.
• 6. Pour oil, lemon juice, and yeast mixture into the hole in the flour. Secure the lid.
• 7. To mix the dough, turn the machine on High for 1 second. Stop the machine. Remove lid.
• 8. While the dough rests, lightly coat a loaf pan with vegetable cooking spray or shortening.
• 9. To knead dough, two steps are required: Step 1: Use a nylon spatula to scrape the sides of the container. Pull the dough away from the container sides and into the center of the mixture. Step 2: With the switch on High, quickly turn the machine on and off five times.
• 10. Repeat the above two-step process five times, or until the dough binds together in a soft elastic mixture.
• 11. To remove the dough from the container, turn the machine on and off five times (to lift the dough up and away from the blades). Invert the container over the prepared pan and let the dough fall into the pan. Use a wet nylon spatula to remove any remaining dough.
• 12. Use a wet (or oiled) nylon spatula to shape the loaf. Allow the dough to rise until the top of it reaches the top of the pan, about 15 to 20 minutes.
• 13. Bake at 350°F for 35 minutes. Makes one loaf.

Steps:

• Add ingredients to bread machine in the order given, or according to your machine instructions.
• Set on whole wheat or basic cycle. On my very old Black and Decker machine I use the powdered milk/wheat setting.
• This is a high rising whole wheat bread, and the large recipe usually squashes at the top of my machine. I can give small and medium versions if you send a private message.

Steps:

• Add ingredients in the order given to bread machine.
• Set on dough cycle if baking in oven, otherwise set on whole wheat/2 lb.
• After dough cycle is done remove dough from pan and flour a work surface lightly. Flour the top surface of the dough.
• Punch down the dough, rolling it into a length equal to 2 greased loaf pans. This might take some work, the dough holds a lot of air. Squeeze and roll the air bubbles out.
• When you have a roll double the length of of a pan cut it in half and place in the greased pans. Cover with a tea towel and set aside in a warm place to rise until doubled in size.
• Rising usually takes about 45 minutes.
• Preheat oven to 350 degrees.
• Bake loaves for 20 to 25 minutes, until browned. Turn out onto a rack and cool.

Steps:

• Put all in your bread machine in order according to manufacturer instructions. Bake as a normal loaf.

Steps:

• Place all the ingredients in a bread machine with a 2 lb loaf capacity.
• Put the ingredients into the pan more-or-less in the order given- wet ingredients first, yeast last.
• This will allow you to use a timer if desired.
• Use the whole wheat setting on the bread machine to bake the bread.
• (cooking times will vary according to your bread machine)

Steps:

• Place warm water, milk, oil, honey, salt, oats, oat flour, wheat flour, baking flour, and yeast in the pan of a bread machine in the order listed.
• Set cycle for light crust according to manufacturer's instructions.

Steps:

• In a bowl, mix together the whole wheat flour, all-purpose flour, and oat flour until thoroughly combined. In a separate bowl, stir together the yeast, warm water, and sugar until the sugar has dissolved, and let the yeast mixture stand until a layer of foam forms on the top, about 10 minutes.
• Pour the yeast mixture into the pan of a bread machine, and add the flour mixture on top of the yeast. Place the butter along one side of the pan, and spoon the salt on the other side of the pan (flour mixture is in center). Set the machine to the White Bread setting and Normal time, and turn on the machine.
• After baking, allow the bread to cool on rack before slicing.

Steps:

• Put all ingredients in bread pan in the order listed. Program for basic white and start.

Steps:

• Place warm water, butter, honey, whole wheat flour, flaxseed meal, vital wheat gluten, salt, dry milk, and yeast in a bread machine in the order listed. Run a basic wheat bread cycle, but adjust the cook timer to cut baking time down by 25 to 30 minutes. I time the bread and take it out when I see that it is not yet brown. If you like a crusty bread you may let it cook the entire time.
• Remove loaf from the machine after the cycle is done.

Steps:

• Follow your breadmaker's instructions regarding how to add ingredients. My breadmaker requests me to do the following:.
• Add liquids to the bread pan first, then dry. Level the dry; quarter the butter and add to corners. Make an impression in the center of the dry ingredients and add the yeast.
• If bread collapses during the baking period, next time add 1 or 1 ½ tablespoons vital wheat gluten to the recipe to prevent from happening again.
• I set my bread maker to 'whole wheat', 'light crust', '2 lb loaf'.