Breadmachinesesamefrenchbread Recipes

Steps:

• Measure ingredients into baking pan in order listed.
• Black& Decker Setting 6 (Specialty- French 3H 30M cycle).

Steps:

• Add 3/4 cup water, salt, flour, parmesan cheese, garlic powder and yeast to bread machine pan in order suggested by manufacturer.
• Select dough/manual cycle.
• When cycle is complete, remove dough from machine to a lightly floured surface.
• Roll dough into a 15x10 inch rectangle.
• Beginning at long end, roll up tightly as for jelly roll.
• Pinch seams and ends to seal.
• Taper ends by gently rolling back and forth.
• Place loaf, seam side down on a greased baking sheet sprinkled with cornmeal.
• Lightly brush loaf with oil.
• Cover and let rise in warm draft-free place until almost double in size, 10 to 15 minutes.
• With a sharp knife, make 3 or 4 diagonal cuts about 1/4 inch deep across the top of loaf.
• Lightly beat egg white and 1 tablespoon water; brush some of egg white mixture over top of loaf.
• Bake at 375 for 20 minutes.
• Brush again with remaining egg white mixture and sprinkle with sesame seeds.
• Bake 5 to 10 minutes more or until done- bread should sound hollow when tapped.
• Remove the bread from the baking sheet and cool on a wire rack.

Steps:

• In a large bowl, dissolve yeast in warm water. Add the sugar, oil, salt and 4 cups of flour; beat until smooth. Add enough remaining flour to form a soft dough. , Turn onto a floured surface; knead until smooth and elastic, 6-8 minutes. Place in a greased bowl, turning once to grease top. Cover and let rise in a warm place until doubled, about 1 hour. , Punch dough down. Divide in half. Roll each half into a 15x10-in. rectangle. Roll up from a long side; seal well. Place with seam side down on greased baking sheet sprinkled with cornmeal. , Beat egg white and water; brush over loaves. Sprinkle with sesame seeds. Cover with plastic wrap sprayed with cooking spray; let rise until nearly doubled, about 30 minutes. , With a sharp knife, make 4 shallow diagonal cuts across top. Bake at 400° until lightly browned, about 25 minutes. Remove from pan and cool on a wire rack.

Steps:

• Add Water to your bread machine first, then add the sugar, salt, flour and yeast. Put it on your dough cycle. Check consistency of dough during cycle as you may need to add a little water or flour depending on your bread maker. When complete, roll dough out to a 12in long loaf of bread and allow to rest on a lightly floured baking sheet covered by a towel for 1 hour. With a knife cut three diagonal slashes across the top of the bread and then glaze. Bake in a preheated oven at 400F/205C for 15 to 20 minutes or until done. Allow to cool on wire tray, then enjoy.

Steps:

• put in machine in order and push buttons to make a 1.5 Lb french loaf.

Steps:

• Place the water, sugar and yeast in the pan of the bread machine. Let the yeast dissolve and foam for 10 minutes. Add the oil, flour and salt to the yeast. Select Basic or White Bread setting, and press Start.

Steps:

• Place all the ingredients into the bread machine according to manufacturer's directions.
• Bake using french bread cycle if your machine has it.
• If not, use the dark crust white cycle.
• Start with 2 3/4 cups flour, you might need more depending on a lot of factors.
• My favorite way to get the texture I like is about 10 minutes into the knead cycle I will pinch a good size chunk of dough between my thumb and two or three fingers.
• If it feels just moist and some dough sticks to my fingers, it's just right.
• If no dough sticks, it's a bit dry and add a few teaspoons of water.
• If it feels too soft and very sticky, add more flour until you get the right consistency after about another 5 minutes of kneading.

Steps:

• Add all ingredients to your bread machine as your directions instruct.
• Mine go like this:.
• Add liquid ingredients to bread pan.
• Add all dry ingredients, except yeast, to bread pan.
• Make a well in the dry ingredients and carefully add the yeast into the well.
• Select the "French" setting on your machine.
• Select crust color, if applicable.
• Press start!
• OVEN METHOD:.
• To make loaves in the oven, use the "Dough" cycle on your machine.
• When cycle is complete, punch dough down and divide into 2 equal parts.
• On a lightly floured surface, roll each half into a rectangle, about 10 x 15.
• Starting at the long side, roll each rectangle, jelly roll style, into a tight, long loaf. Seal seams and ends by pinching dough together.
• Place loaves seam sides down on a large, ungreased baking sheet. You may sprinkle some cornmeal or flour on the pan under where you'll be placing the loaves.
• Cover loaves with a clean towel and let rise in a warm place for about 30 minutes, until almost double in size.
• Preheat oven to 375*. Place a pan of hot water on the bottom rack of your oven. This will create steam inside the oven while the bread is baking to give you an authentic crust.
• Using a very sharp knife, carefully make 3 or 4 diagonal slashes in each loaf, cutting about 1/2 inch down into dough.
• If you choose, at this time you can carefully brush on an egg white glaze (one egg white beaten with 1 tbl. of water) and sprinkle with sesame seeds, poppy seeds, dried onion or garlic, etc., if desired.
• Bake for 25-30 minutes (or until loaves sound hollow when tapped) on middle oven rack.
• Cool on wire racks and serve warm.

Steps:

• Put the ingredients in the machine in the order listed.
• From time to time, check the dough.
• If too dry add water, if too wet add flour, always one tsp at a time.

Steps:

• Add ingredients in the order listed to your bread machine, or follow the manufacturers directions for adding ingredients.
• Choose the basic cycle with regular or light crust. Rapid cycle will work, too.