Red Enchilada Sauce Salsa De Chile Rojo Recipes

Steps:

• Heat the oil in a large saucepan over medium heat. Add the garlic and saute for 1 to 2 minutes. Add the onion, oregano, chili powder, basil, ground black pepper, salt, cumin, parsley, salsa and tomato sauce.
• Mix together and then stir in the water. Bring to a boil, reduce heat to low and simmer for 15 to 20 minutes.

Steps:

• Preheat oven to 375°F.
• Place chiles on a wire cooling rack on a baking sheet.
• Roast 4-5 minutes, NO MORE THEY"LL TURN BITTER!
• Let them cool to touch.
• Cut tops off, split in two with a sharp knife.
• Remove seeds and veins, the soft part that holds the seeds.
• Cover with boiling water, let steep an hour.
• Remove each half to a platter and scrape the pulp with the edge of a spoon. After handling chiles wash your hands with warm water and baking soda to nutralize the chile juice. It's an acid. You can safely wash your eyes too.
• Combine all ingredients including the water in a sauce pan.
• Bring to a simmer, simmer for 15 minutes.
• Stirring occasionly.

Steps:

• 1. Rinse the ancho chiles and the chiles de arbol under cold water and pat dry. Remove the stems. Toast the chiles in a dry pan or comal over medium low heat until fragrant. Keep turning the chiles so they don't burn. You can also use a toaster oven, but be sure to watch the chiles closely so they don't burn. I find the toaster oven method easier because the ancho chiles are not flat. Toast the two different types of chiles separately.
• 2. Sautee onion until translucent. Add garlic and diced tomatoes and saute for another minute.
• 3. Bring six cups of water and bouillon to a boil and add all of the chiles, onion, tomato, and garlic. Reduce the heat and simmer for fifteen minutes.
• 4. Transfer the contents of the pan to a blender and add the oregano and cumin. Place a towel over the top of the blender while blending to protect from any splatters. Blend for two minutes until the mixture is very smooth. Be careful because the mixture is very hot. Hot contents can cause the lid to fly off your blender, so just use the towel.
• 4. Return the contents of the blender back to the pan by forcing the mixture through a strainer with the back of a spoon to remove the seeds and tough bits of chile skin that remain. Don't skip this step.
• 5. Simmer the strained enchilada sauce for 15 minutes to blend the flavors. Add salt to taste.
• This recipe makes about 4 cups of finished salsa. Store the salsa in the refrigerator for 3 days or in the freezer for one month.

Steps:

• Soak chiles in warm water until softened, about 30 minutes. Drain; strain and reserve liquid. Remove stems and seeds and membranes from the chiles. Cook and stir onion and garlic in oil in a 2-qt. saucepan until onion is tender. Add chiles and 2 cups of the reserved liquid , the tomato sauce, oregano, cumin and salt. Simmer uncovered 20 minutes. Cool.
• Transfer to blender container; cover and blend on low speed until smooth. Strain. Refrigerate sauce no longer than 10 days.
• Note: I strain mine in a mesh strainer or colander. It takes a few minutes, but keep thinking of how great this is going to taste!

Steps:

• Stem serranos, and puree along with garlic in blender until smooth adding water if necessary to maintain puree.
• Press puree through a sieve to remove seed particles.
• Combine 40 oz. serrano puree with all other ingredients in bowl.
• Work in batches back through blender, and strain again.
• Bottle in sprinkle top bottles and refrigerate.

Steps:

• Remove stem of ancho chilis and tear open to expose seeds and create an open and flat chili. Discard seeds.
• Place chili one at a time SKIN side down on a SCREAMING HOT skillet or grill pan. The chili should pop and crackle a little as you press it flat and hold it against the scorching hot surface with a metal spatula while you count one cerveza two cerveza three cerveza! Remove from pan and repeat until all chilis are seared. (NOT the pequin tho!).
• Now place the seared Ancho chilis in 1 cup VERY HOT water and weigh them down with something so they stay submersed. I use a potato masher bc it stands by itself and is easy to remove.
• Soak chilis for about 15-20 minutes. Drain and discard soaking water.
• Meanwhile, chop, dice and measure remaining ingredients.
• In a blender combine drained chilis, chili pequin, tomatoes, garlic, 1 onion- reserve the other to add later, cilantro, sugar, lime juice and broth or juice. Pulse until smooth. (I use what I have on hand. Try to match the broth to whatever dish you are preparing or use V8 or tomato juice.).
• Heat oil in the skillet used previously or a heavy pot. Add celery, onion, and green pepper and saute until they begin to soften. (I like to keep the pieces rather large, about 1 inch in size.).
• Remove from heat and pour all ingredients from blender into hot pan. IT WILL splatter and pop! Be careful! Return to burner and whisk over high heat until the mixture comes to a boil.
• Reduce heat immediately and continue whisking periodically for about 10 minutes or until sauce is thick.
• Use immediately or transfer to a glass jar with tight fitting lid, cool and store in refrigerator until ready to use.
• Note: I have hot packed this into a sterilized glass canning jar. It never lasts long in my house so I do not know how long it keeps.