Bbq Rib Eye Steak Recipes

Steps:

• Preheat a grill to high heat.
• Place rib-eye steaks on a large platter and season with rub on all sides. Transfer seasoned steaks to the hot grill, and cook for 4 to 6 minutes on each side for medium-rare, longer if desired. Remove steaks and let rest for 5 to 10 minutes before serving.
• In a small bowl, combine all ingredients, to taste. Adjust the ratio of spices to your preference.

Steps:

• For the marinade: Combine garlic, rosemary, and olive oil in glass dish or stainless-steel bowl. Place steaks in olive oil mixture. Marinate steak for 1 hour before cooking.
• For the sauce: On a low heat, melt butter in a small saucepan. Add grated onions, minced garlic, and sugar. Using a wooden spoon, stir mixture well for approximately 3 minutes. Add remaining ingredients. Allow sauce to simmer 8 minutes stirring occasionally.
• To prepare the steak: Heat cast iron skillet (with grill marks) until skillet is very hot. Remove steaks from marinade and pat semi-dry. Place steaks in hot skillet and cook to desired temperature. Baste steak with BBQ sauce to taste.

Steps:

• Let steaks stand at room temperature 15 to 20 minutes. Rub steaks evenly with steak seasoning (I use McCormick Grill Mates Montreal Steak Seasoning).
• Grill, covered with grill lid, over medium heat (300 to 350) for 2 1/2 minutes. Using tongs, turn each steak at a 60-degree angle, and grill 2 1/2 minutes more. Flip steaks, and grill 2 1/2 minutes. Turn steaks at a 60-degree angle, and grill 2 1/2 more minutes (medium-rare) or to desired degree of doneness.
• Remove steaks from grill, and brush evenly with butter. Let stand 5 minutes.
• (If you want rare steaks, adjust the time to 2 minutes in the above directions; for medium doneness, grill 4 minutes each turn; and for medium-well, allow about 5 minutes each turn).

Steps:

• Remove steaks from the refrigerator and let them sit for about 30 minutes to take the chill out of the meat.
• Now, coat both sides generously with coarse black pepper and granulated garlic powder.
• Heat an iron skillet or a heavy bottomed frying pan until very hot on high heat.
• For each steak, sprinkle onto the skillet, 3/4 teaspoon of coarse salt and allow salt to heat up for at least 1 minute.
• Place the steaks on the coarse salt and cook for 3 minutes; DO NOT DISTURB at all, DO NOT LOOK or even move the steaks.
• Turn the steaks over and cook for an additional 3 minutes; again DO NOT DISTURB at all.
• The cooking time of 6 minutes gives you a medium-rare steak; DO NOT OVERCOOK.
• If you desire to cook it to medium, then cook for an additional 30 seconds to 1 minute per side.
• Remove steaks to a plate, cover with foil and let rest for 5 minutes, so that all juices are absorbed by the meat.
• Scrape off any excess coarse pepper and salt if desired and discard.
• I prefer to slice the steaks on an angle about 1/4 inch to 3/8 inch thickness.
• Serve with freshly processed horseradish.
• NOTE; Make sure that the heat is on as HIGH as possible without burning at all times during cooking the steaks. This will vary depending on your cooktop.
• Do not use ordinary table salt.
• Beef Tenderloin steaks are also real great cooked in this manner. If using a steak thicker than 1 inch, add 1 extra minute per side for medium-rare.

Steps:

• Heat grill to high; clean and lightly oil hot grates. Let steaks stand at room temperature for 30 minutes. Generously season both sides of steaks with salt and pepper. Grill steaks, rotating once to create hatch marks, until well-browned on the outside and cooked to desired doneness, 6 to 7 minutes per side on a charcoal grill (or 8 to 9 minutes per side on a gas grill) for medium-rare (about 125 degrees). Transfer to a platter; cover with foil. Let rest for 10 minutes. Slice steaks against the grain.